Miata Front Brakes
Time to replace the front calipers, had to replace the rear calipers last year as they were leaking at the parking brake lever seal.
 |
| I decided to do the work while still loaded on the trailer for better ergonomics |
 |
| Forgot to paint the calipers so I have to wait for paint to dry... (also when trying to free a stuck brake piston one can push fairly hard with loose C clamp to use the hydraulics to free it but once the piston moves do not pump the pedal one more time just a bit harder...) |
 |
| Pressure brake bleeder system will make the bleeding process far easier |
 |
| A POX on AutoZone - they gave me the wrong rotors (Then again I should have checked...) so I had time for the paint to dry as I made a trip to town for the correct ones. http://www.mossmiata.com/sitegraphics/pages/factory_big_brakes.html |
 |
| All done and bled - ready for the wheels. Using a lug nut to hold a wobbly rotor is a handy trick when trying to bolt the caliper bracket back on. Also install the new brake line last so you do not need to worry about stressing the hose. (I do not like the Miata front hoses - too short to turn the wheel to full lock when the suspension is unloaded - I thought I got the wrong parts but I checked old to new side by side and they were the same length.) |
 |
| Last brake job of the day - replace the rear brake proportioning valve - much easier to get to than the pair on the 1800ES - nice Subaru part supplier pointed out I only needed one for this vehicle - the 1800ES needs two for the dual split circuit braking system on pre-ABS Volvo's with 4 wheel disk brakes. |
2 Comments:
Why paint the calipers?
I didn't on the Subaru job and the rusted very quickly - used a rust converter and clear on the rear but was out so decided to use high temp black for the fronts.
Post a Comment
<< Home